Arduino based Snake Robot Controlled using Android Application
The snake contains twelve segments motivated by servo motors and joined with metal brackets. The servos are controlled by an Arduino Mega and powered by a 7.4-volt battery pack. The snake can be controlled by an android app using Bluetooth. The snake is also capable of autonomous movement.
Such a robot can be constructed with many different types of servos and brackets. Each of the 12 segments consists of a servo motor, a C-bracket, a side bracket, a wire clip, and a set of Lego wheels. Two screw holes are to be drilled into the Lego wheel axle to permit it to be connected to the C-bracket.
After all, 12 segments are connected, and head and tail sections need to be added in order to accommodate the Arduino and batteries. To make them a side bracket and two long C-brackets connected. The Arduino and therefore the 5AA battery holder are used that powers it into the tail section of the snake.
The servos are powered by a separate supply, the 7.4-volt battery pack, goes into the head of the snake. On the receiver, the bottom pin is connected to the Arduino ground. The voltage pin is connected to a 5-volt pin from the Arduino.
Do You Have New or Fresh Topic? Send Us Your Topic
Arduino based Snake Robot Controlled using Android Application
INSTRUCTIONS AFTER PAYMENT
- 1.Your Full name
- 2. Your Active Email Address
- 3. Your Phone Number
- 4. Amount Paid
- 5. Project Topic
- 6. Location you made payment from